One-component adhesive based on polyvinyl acetate, with water resistance class D1 according to PN-EN 204.
After reaching full strength, the joint has very good adhesion to wood surfaces subjected to static and dynamic loads and ensures good initial adhesion.
Applications:
- Bonding solid wood for production of interior joinery;
- Bonding particle and fibre board;
- Bonding other wood-based material;
- For use in cold press and manual bonding.
Instructions
Material preparation
The surface to be bonded must be dry cleaned and free from dust, without traces of oils and fats that would impair adhesion. Wood humidity should be 8 to 12 [%]. The elements to be bonded should be matched to each other.
Adhesive application
Stir the adhesive carefully before use. The adhesive can be applied on one or two sides with a brush, spatula, applicator bottle, hand roller. The recommended amount of adhesive applied, depending on the type of surface, is 90 to 180 [g/m2].
Discolouration
The adhesive does not cause discolouration of wood, but it is recommended to avoid tools containing iron; in contact with wood containing tannin it may cause discolouration.
Open time
Open time: 3 ÷ 6 [min]. The open time depends on the wood type, porosity of the wood, humidity and air temperature and the amount of adhesive applied. Bonding is possible for as long as the adhesive is wet (white).
Bonding temperature
Use in temperatures 15 [°C] ÷ 25 [°C]. Applies to the ambient temperature, especially the temperature of the material bonded and the adhesive.
Pressing
Pressing pressure — in the range 0.1 to 1.2 [N/mm2] according to the stress occurring in the bonded materials. In case of manual application, the press the surfaces to be bonded together to squeeze out the adhesive excess.
Pressing time — depends on the type of wood and its moisture content, temperature and relative humidity of air and the amount of adhesive applied and the stresses occurring in the bonded materials. Press the bonded components until the initial strength is achieved.
Average pressing times suggested:
- Cold press 15 ÷ 30 [min].
Good results can be achieved wile bonding observing the following conditions:
| Bonding temperature | 15 ÷ 25 [°C] |
| Relative air humidity | 40 ÷ 70 [%] |
| Wood humidity | 8 ÷ 12 [%] |
| Amount of adhesive applied | 90 ÷ 180 [g/m2] |
| Maximum open time | 3 ÷ 6 [min] |
Cleaning
Wash the tools in water immediately after completing the work. Do not allow the adhesive to dry out. Mechanically remove dried adhesive from tools after soaking in hot water for 1 hour.
Packaging
Product is available in 20 kg, 60 kg and 1000 kg plastic containers.
Packaging and transportation are not subject to RID/ADR regulations. Other containers can be provided upon agreement between the manufacturer and customer. The packaging may not affect the quality of product.
Storage
Store in original tightly closed containers at temperature range from + 13 to + 30 [°C]. Product stored in such conditions does not change its properties in the period of 12 months from the date of production.
