Adhesive melt Henkel TECHNOMELT KS 250 COOL for edgebanding

Клей расплав для наклеивания кромки Henkel TECHNOMELT KS 250 COOL
Order products
Adhesive melt Henkel TECHNOMELT KS 250 COOL for edgebanding
Send and our managers will contact you to clarify the details of the order

Description and characteristics — Adhesive melt Henkel TECHNOMELT KS 250 COOL for edgebanding

Adhesive melt for edgebanding of Henkel TECHNOMELT KS 250 COOL (formerly DORUS KS 250 COOL) — glue-melt based on EVA

Adhesive melt Henkel TECHNOMELT KS 250 COOL has the following characteristics:

Technology EVA
Product type Melt adhesive
Application Edge clipping
Appearance Granules, Natural

Areas of Application

  • Edgebanding on passing equipment from 15 m/min
  • Edge material: veneer, melamine, polyester, HPL*, PVC*, ABS*, PP*
  • Softforming of complex profiles
  • Can be used on manual edge banding equipment

* Applicability depends on the characteristics of the edge material and priming.

Product Properties

  • Low viscosity
  • Little filled
  • Very good thermal stability
  • Forms a rigid adhesive seam
  • High efficiency
  • Very good wetting of surfaces to be cleaned
  • Very clean application
  • High bond strength after full polymerization

Technical data Henkel TECHNOMELT KS 250 COOL

Softening point (ring and ball), °C ~100
Brookfield viscosity is 140 °C, mPa*s ~100 000
Brookfield viscosity is 180 °C, mPa*s ~15 000
Temperature resistance, °C (Tested on 0.6 mm oak veneer using the Henkel standard temperature increase technique) ~85

Recommendations for use

Before use, read the Safety Data Sheet for information on safety precautions and safety recommendations. Always take precautionary measures. Please always follow the internal safety instructions. If necessary, contact Henkel for support.

Instructions for use of the adhesive melt Henkel TECHNOMELT KS 250 COOL

Operating temperature

  • Recommended operating temperature: in the melting tank — 140-160 °C
  • Recommended operating temperature: on the applicator roller — 140-160 °C

Safety precautions

Melt adhesives release volatile substances even within operating temperatures. The smell of vapors may cause irritation. Long-term temperature influence on the melt can cause partial decomposition of the glue. Therefore, it is necessary to take measures to ensure the removal of vapors from the working area, for example, by installing aspirating equipment.

Storage of melt adhesive TECHNOMELT KS 250 COOL

Store in original tightly closed container in a cool dry place. Shelf life (in the original packaging) is 2 years.