Adhesives for wood Woodmax P 11.583
Description and characteristics — Adhesives for wood Woodmax P 11.583
One-component adhesive based on polyvinyl acetate with enriching additives for making elastic joints.
After achieving full strength, the joint offers very good adhesion to paper, and moderate adhesion to wood, wood-based product and plastic surfaces.
- Bonding paper;
- Bonding cardboard;
- Gluing labels to glass and plastic containers;
- Bonding internal parts of shoes;
- Bonding paper to wood;
- Bonding particleboards and fibreboards;
- Bonding textile to wood;
- For use in cold press and manual bonding.
The surface to be bonded must be dry cleaned and free from dust, without traces of oils and fats that would impair adhesion. The elements to be bonded should be matched to each other. Wood humidity while bonding should be 8 to 12 [%].
Stir the adhesive carefully before use. The adhesive can be applied on one or two sides with a brush, spatula, applicator bottle, hand roller. The recommended amount of adhesive applied, depending on the type of surface, is 120 to 180 [g/m2].
Open time: 3 ÷ 10 [min]. The open time depends on the type of components bonded, wood type, porosity, humidity and air temperature, and the amount of adhesive applied.
Use at above + 5 [°C]. This applies to the ambient temperature and, especially the temperature of the material bonded and of the adhesive.
Pressing pressure — in the range 0.1 to 1.2 [N/mm2] according to the stress occurring in the bonded materials. In case of manual application, the press the surfaces to be bonded together to squeeze out the adhesive excess.
Pressing time — depends on the type of material bonded, porosity, absorption, wood type and its moisture content, temperature and relative humidity of air and the amount of adhesive applied and the stresses occurring in the bonded materials. Press the bonded components until the strength is achievedallowing further processing or transport.
Average pressing times suggested:
- Cold press 15 ÷ 30 [min].
Good results can be achieved wile bonding observing the following conditions:
|Bonding temperature||15 ÷ 25 [°C]|
|Relative air humidity||40 ÷ 70 [%]|
|Wood humidity||8 ÷ 12 [%]|
|Amount of adhesive applied||120 ÷ 180 [g/m2]|
|Maximum open time||3 ÷ 10 [min]|
Wash the tools in water immediately after completing the work. Do not allow the adhesive to dry out. Mechanically remove dried adhesive from tools after soaking in hot water for 1 hour.
Product is available in 20 kg, 60 kg and 1000 kg plastic containers.
Packaging and transportation are not subject to RID/ADR regulations. Other containers can be provided upon agreement between the manufacturer and customer. The packaging may not affect the quality of product.
Store in original tightly closed containers at temperature range from + 5 to + 30 [°C]. Product stored in such conditions does not change its properties in the period of 12 months from the date of production.